CE Approved Copper Wire Recycling Machine Copper Cable Shredder
TF-400(capacity:150-200kg/h) Copper Wire Recycling Machine is
suitable for middle size factory. It finishes the complete
recycling process in closed structure to avoid pollution and noise.
Crushed copper wire go through the high pressure fan, and dust
inside will be cleaned and finally vibrating separator will take
out clear copper and plastic pellet from different exit.
Scrap copper cable recycling machine advantages:
1. Integrated structure, small dimensions, easy to move, saving
2. Low power consumption, stable performance.
3. Minimum copper recycling rate can reach 99%.
4. No water is needed, no dust, no environmental pollution.
5. Controlled by electricity control panel, highly automatic.
Waste copper wire recycling machine Application(raw materials):
Applicable cables: Waste communication copper cables, motor cable,
car cable, industrial cable,household cable, enamelled cable.
Applicable cable diameter: 0.3-20mm
Scrap Copper Wire Recycling Machine Specifications:
|Model||Recycling capacity||Processed wire dia.||Total power||Voltage||Dimension||Weight|
Scrap copper cable recycling machine Working principle:
1. Put wires and cables into the crusher, in which they are crushed
and plastic sheath and copper separated completely. The length of
the crushed material is based on the mesh of the riddle: the bigger
the mesh is the longer the crushed material will be and the larger
the output will be. The mesh should be chosen in production
according to the type of the material.
2. The crushed material (mixture of copper granules and plastic
pieces) is conveyed to the separator by the conveyor, during which
procedure dust and part of plastic pieces of light weight(including
fiber, rope, or tapes, etc. mixed in the wires) are collected by
the pressure-reducing blower. The above opening of the pressure
reducing blower is connected with the dust collector opening in
which a dust collecting bag is used to prevent discharge of dust
for the purpose of environmental protection. Dust and part of
plastic pieces of light weight are collected in this bag and will
be discharged when the bag is full.
3. The Copper Wire Recycling Machine is used for separating plastic
pieces and copper granules. According to the differences of the
physical properties and specific gravity between different
materials, there is specific gravity deviation under the forces of
Aerodynamic and Vibration friction. By adjusting the speed of
material conveying and amplitude parameters, copper granules (of
larger specific gravity) will move to the riddle bottom and move
from down to up, and plastic pieces (of smaller specific gravity)
will move to the above of copper granules and move from up to down,
and in the end they will both be discharged through different
4. All the units are installed on the underbed to form a whole
structure. The machine is adjusted ready for production before
shipping, and the customer only need to connect it to the power